BC40019(Satin Chrome) & BC40112(Matte Black) Lever Grade 2 HD Keyed Entry – Brinks.Care

The Brinks Commercial Heavy Duty Keyed Entry Lever is designed for entry doors or doorways where added security is needed. Turning the inside button locks outside lever until unlocked with a key or turn button is manually unlocked. A 5-Pin SC1 cylinder and brass plug provide added security and peace of mind. Equipped with tubular chassis for easier installation, the keyed entry lever will fit wood or metal doors 1-3/8" to 2" thick. The Heavy Duty Keyed Entry Lever features 4-5/8" solid zinc diecast levers, an ANSI Grade 2 rating that's tested to exceed 500,000 cycles, a 3 hour fire rating (UL Listed) and is ADA compliant for commercial or residential use. A T-strike, 4-7/8" ASA strike, 2 keys, mounting hardware and installation instructions are included.

Equipped with 4-1/2" solid zinc diecast levers
Sleek satin chrome finish
Heavy duty cylindrical construction
Packaged with 4-7/8" ASA ANSI strike and T-strike
ANSI Grade 2: Tested to exceed 500,000 cycles
UL Listed: 3 Hour fire rated for added protection and meeting building requirements
ADA Compliant: Meets ADA requirements, ensuring accessibility to all disabled persons
Included 6-Pin SC4 Cylinder, brass plug and 2 keys for added security and piece of mind
Full lifetime warranty
Door Type: Wood or Metal doors 1-3/8"-2" thick
Non-Handed: Can be applied to left or right handed doors
Included hardware: Mounting screws, 2 keys and installation instructions
Fixed cylindrical 2-3/4" backset latch included

To adjust the door thickness base plate on chassis

To remove exterior lever insert the key and rotate the key 90 degrees clockwise. While the key is turned insert the push pin into the hole on the side of the exterior lever, depress the catch and remove lever.
Remove exterior rose with spring cage
Determine thickness of door
Rotate base plate to its furthest position
Using the provided door thickness guide, place the dotted line of your door thickness next to the edge of the chassis body and rotate the base plate back to the required distance.

Rotate to D for 2" thick door:

Rotate to C for 1-3/4" thick door:

Rotate to B for 1-9/16" thick door:

Rotate to A for 1-3/8" thick door:

Once properly adjusted reinstall the exterior rose and spring cage, be sure to align the tab on the exterior spring cage to the channel on the side of the exterior spindle.

And align the four slots on the base plate to the four raised spots on the rose, rotate the base plate slightly to match if necessary.

Reinstall the exterior lever.

Slide the lever onto the spindle until it stops.

Then rotate the key 90 degrees clockwise and push the lever until it locks into place.

Rotate the key back and remove.

Install the exterior assembly, check that the chassis is properly connected to the latch. The latch tail should be inserted into the retractor and the prongs of the latch are between the retractor and chassis body.