4390-XXX, 4391-XXX, 4392-XXX Brinks Electronic Deadbolt

 

4390-XXX                                   4391-XXX                                                    4392-XXX

• https://brinkslocks.com/residential/products?Category=Electronics

• Program one 4-8 digit master code
• Up to 50 different additional user codes
• 10 single-use codes.
• Optional auto relocking with an adjustable delay from 1-99 seconds.
• Vacation Mode: Temporarily deactivate all user codes.
• Batteries last up to 24-months or longer. 2x greater than the leading competitor.
• Low Battery Alerts: Audio and visual alerts when it's time to change the 4-AA batteries.
• Unlocked Alert: Green flash continuously until locked.
• Bolt Jam Alarm: Flashes Red and three double beeps every 10 seconds until cleared
• Features PRO-GUARD advanced security and protection including anti-tamper alarm, anti-pry shield, and a pick/bump/drill resistant cylinder.
• KW1 keyway 
• Can be re-keyed by a locksmith
• It is unlikely that Schlage or a secondary supplier with SC1 deadbolt cylinders makes one with dimensions that will fit as needed

Interior all finishes:

System Alerts

Beeping fast 6 times every 10 to 15 seconds after successfully programing lock:

Alignment issue. Check by opening door, remove batteries for 10 seconds, reinstall and beeping will have stopped. If occurs again after door is closed and locked, check bore hole for alignment, obstruction, depth issues. Lock is working correctly and replacement will not correct issue.

Before resetting a lock:

Un-installing the batteries and waiting a minute or two before reinstalling

Trying a different set of batteries, also waiting a minute or two before installing

Backing the S4 interior assembly screws out a turn, we do get quite a few calls that this step alone corrects programming issues

Disconnecting the IC wire, waiting a minute or two before reconnecting

Reset Won't cycle the lock?

Remove the batteries and reinstall, it will then run identification.

When step 1 programming master code, it gives 3 red beeps

If you receive red beeps after entering your master code during step 1 please follow these steps-

1. Factory reset the electronic deadbolt.
   • You do this by pressing the reset button underneath the inside housing unit with the reset tool or an object that will fit in the reset hole, until you hear a long beep.
2. Once reset, take 1 battery out, wait for a few seconds and then put the battery back in. Allow the bolt to go out and back in. (You will hear a beep)
3. After success, attempt step 1 again. If successful you will hear 1 beep, and the button will turn green.

Initial keypad locks will shut down for 1 minute after 3 consecutive unsuccessful attempts.

All Fingerprint locks and Keypads received after July will shut down after 5 wrong unsuccessful attempts.